Lifts and fire safety: can you use a lift in an emergency?
When a fire alarm goes off, plenty of people press the lift button out of habit. It is exactly what you should not do. In this article we look at how lifts behave during a fire, the myths that keep doing the rounds, and what to do if a fire breaks out at home, at work or in a residential block.
Why lifts should not be used during a fire
A lift shaft is a vertical duct running through the whole building. In a fire, smoke and hot gases rise through it much like a chimney, and they can reach the car within minutes.
There is also a very practical risk: fire often damages the electrical supply. If the power goes, the car stops, sometimes between two floors, with people inside who cannot get out on their own.
On top of that, the car could open its doors on the very floor where the fire is. That is why the sign next to almost every lift is so blunt: in the event of fire, do not use the lift.
Common myths about lifts and fires
"If the lift is working, it must be safe"
A lift answering your call tells you nothing about what is happening in the shaft or on other floors. It can run normally for the first minute and fail halfway down.
"The lift is quicker than the stairs"
In an evacuation, the stairs are the route designed for the job. In many buildings they are protected against smoke, and they do not depend on electricity.
"If I get stuck, I will run out of air"
Lift cars are not airtight; they have ventilation openings. In a fire, the real danger is not a lack of air but smoke getting in and the time it takes for help to arrive.
"Every lift goes down to the ground floor on its own when the alarm sounds"
Only lifts with that function fitted and linked to the building's fire detection system do this. Many residential lifts, especially older ones, do not have it.
"Firefighters never use lifts"
They do, but not just any lift. They use firefighting lifts, built to keep working in those conditions and operated only by them.
What happens to lifts when the fire alarm goes off
Lifts designed to the European standard EN 81-73 follow a set procedure in a fire. When they receive a signal from the detection system, they stop answering calls, travel to a designated floor (usually the main exit level) and open their doors so passengers can leave.
They then go out of service. If the fire has been detected on that very floor, the system can send the car to an alternative one. If you are not sure whether your lift has this function, your maintenance company can tell you.
Firefighting lifts: the only ones meant for use in a fire
In Spain, the fire safety section of the Technical Building Code (CTE) sets out the requirements for emergency lifts. They are required in buildings where the evacuation height exceeds 28 metres, and during a fire they are reserved for the fire service.
The specifications are precise: a minimum load of 630 kg, a car of at least 1.10 x 1.40 metres, a full journey in under 60 seconds and an independent power source that lasts at least one hour if the mains supply fails.
On the access floor there is a button under a glass cover marked "USO EXCLUSIVO BOMBEROS" (fire service use only). Once it is activated, the lift returns to that floor and can only be operated from inside the car.
What to do if there is a fire in your building
At home or at work
Call 112 as soon as you see fire or smoke. Leave by the stairs, closing doors behind you to slow the smoke, and do not go back in for anything.
If there is smoke on the stairs, stay low, as the air is cleaner near the floor. If you cannot get out, stay in a room with a window, block the gaps around the door with wet towels and tell the 112 operator exactly where you are.
If you are inside the lift
If the car stops, press the alarm button, which puts you through to the service that organises the rescue. Do not try to force the doors or climb out through the roof: the risk of falling is real.
If the lift stops at a floor and the doors open, get out and head for the stairs.
People with reduced mobility
Ideally, the residents' association or employer should cover this in the building's emergency plan: who helps, which route to take and where to wait for the fire service if going down is not possible.
Lift maintenance and regulations: what to check
A well-maintained lift copes better with any emergency. Routine inspections check that the alarm button and communication system work, that doors and brakes respond properly and that the car has emergency lighting.
If the building has automatic fire recall or a firefighting lift, the maintenance visit should test those functions and their link to the fire detection system.
Spanish regulations require lifts to be maintained by an authorised maintenance company and to pass periodic inspections. If you live in a residential block, ask your property manager when the last inspection took place and what the result was.
How General Elevadores can help
We have more than 30 years of experience in lift maintenance, installation and modernisation, and we work with lifts of any make. We also run a 24-hour emergency service for urgent breakdowns.
If you would like to know how your lift would react to a fire alarm, we can go through it with you. Get in touch with your nearest office or, for urgent cases, call our emergency line on +34 607 514 040.